Greenlee DM-70 Manual De Instrucciones página 8

Operation
1. See the Settings Table. Set the selector to the proper setting, press RANGE
(if instructed to do so), and connect the test leads to the meter.
2. See Typical Measurements for illustrations of typical uses.
3. Test the unit on a known functioning circuit or component.
• If the unit does not function as expected on a known functioning circuit, replace the
batteries.
• If the unit still does not function as expected, send the unit to Greenlee for repair. See
the address shown under Warranty.
4. Take the reading from the circuit or component to be tested.
Settings Table
To measure
this value ...
Continuity*
Current
(3200 µA max)
Diode
and press RANGE once
Resistance
Voltage
* Tone indicates continuity. The threshold is approximately 15 Ω.
8
All manuals and user guides at all-guides.com
Electric shock hazard:
Contact with live circuits can result in severe injury or death.
set the selector
to this symbol ...
Ω
or
this icon will connect
appear on the red
the display ... lead to ...
µA
VΩµA
Ω
V
and connect
the black
lead to ...
COM