Input/Output (I/O) Setup; Percent Weighing - OHAUS Defender Serie Manual Del Usuario

EN-44

4.3.4 Input/Output (I/O) Setup

The I/O's setup can be customized for various user preferences.
The I/O's setup is defined below (defaults in Bold).
Item
Enable
Discrete Input 1
Discrete Input 2
Discrete Output 1
Discrete Output 2
Discrete Output 3
Discrete Output 4
Note: The I/O's will only work when the I/O Option board has been installed. The option I/O board
provides two isolated inputs and four dry-contact normally open relay outputs which can be used for
simple process weighing.
Press the button
With the button corresponding to the icon
go down the list and highlight Application Mode.
Enter this sub-menu by pressing the button
corresponding to the icon
In the Application Mode menu enter the Check
sub-menu.
The Check sub-menu is now displayed.
Select the list item and press the Softkey
corresponding to the icon
setting as desired.
setup, press the Softkey corresponding to the
icon to return to the main application
screen.

4.4 Percent Weighing

Use Percent Weighing to measure the weight of a sample displayed as a percentage of a pre-
established Reference Weight.
Press the button
to Percent is displayed in the upper left portion of the
home screen.
Establish a reference weight according to section
4.4.1 and then place the objects on the pan to display
the percentage.
The default (or last) Reference Weight is displayed on
the main screen.
Available Settings
On, Off
Off, Zero, Tare, Clear Tare, Print, Unit, Accumulate
Off, Zero, Tare, Clear Tare, Print, Unit, Accumulate
Off, Under, Over, Accept, Under/Over, Zero
Off, Under, Over, Accept, Under/Over, Zero
Off, Under, Over, Accept, Under/Over, Zero
Off, Under, Over, Accept, Under/Over, Zero
to enter the Main Menu.
.
to change the
After completion of I/O's
until the icon corresponding
,
Defender 5000 Indicators