Step 9
Carefully turn your unit over onto its front edges. Unfold
å
the BACK (O) and lay it over your unit.
Make equal margins along all four edges of the BACK (O).
å
Push on opposite corners of your unit if needed to make
it "square".
Fasten the BACK (O) to your unit using the NAILS (11).
å
NOTE: Be sure to tap NAILS into the holes that line up
å
over the SHELVES (E, F, and G).
NOTE: Perforations have been provided for access
å
through the BACK. Carefully cut out the holes needed.
These holes must line up over
the SHELVES (E, F, and G).
420282
O
www.sauder.com
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
NAIL
(53 used in this step)
This hole must be here
for the FURNITURE
TIPPING RESTRAINT
KIT in the next step.
For support, place packing
foam and magazines here.
11
Page 13