How To Capture Slo Images; Figure 9: Slo Capture Workflow - Nikon Optos Monaco P200TE Guia Del Usuario

3.2.4 How to capture SLO images

To capture SLO images use the procedure below. You have the option to capture the following image
modalities:
opto map
l
opto map plus
l
opto map af
l

FIGURE 9: SLO capture workflow

1. Select the required SLO light and resolution types. You should select
or opto map plus
2. Position the patient, see How to prepare for image capture on page 36 .
3. Align the patient, see How to align the patient on page 37 .
4. Ask the patient to open both eyes wide, look at the center of the alignment target and to move closer
until they can see the target. Make sure the patient can see the target, that the target is green and that
the cross hairs are close to the center of the pupil.
5. Capture the image either manually or using auto-capture.
Auto-capture : Auto-capture is enabled when
l
screen. The system captures an image when the scan head is correctly aligned. You can
press the screen to manually capture the image. Auto-capture is turned off after capturing an
image.
Manual capture : Align the scan head into the correct position. Press the screen to capture
l
the image when the pupil is in the center of the cross hairs and the patient alignment target
is green. You can also capture using the hand control.
6. Check the quality of the images, see What to do after the image is captured on page 41 .
Part Number: G108707/8GCA
Copyright 2018, Optos plc. All rights reserved.
.
Red/Green or
Automatic is shown in green on the touch
Chapter 3 - How to...
AF and opto map
Page 39 of 76
English