KALLISTA P21510 Instrucciones De Instalación página 3

INSTALLATION INSTRUCTIONS
CAUTION: Risk of product damage. To avoid plugging the showerhead spray outlets, use thread sealant tape
on the shower arm threads. Do not use thread sealant compound.
NOTE: The shower arm is not provided.
‰ Slide the escutcheon onto the end of the shower arm that will be closest to the wall/ceiling.
‰ Install the shower arm onto the shower ell according to the shower arm manufacturer's instructions.
‰ With the showerhead off, turn on the water to flush out the system.
‰ Apply thread sealant tape to the threads of the exposed end of the shower arm.
‰ Handtighten the showerhead to the shower arm.
‰ Use a clean adjustable wrench to tighten the showerhead onto the shower arm.
‰ Check for proper operation.
‰ Check all connections for leaks. Repair as needed.
‰ If desired, apply a bead of clear silicone sealant to the back perimeter of the escutcheon.
‰ Carefully slide the escutcheon to the finished wall/ceiling; be careful not to scratch the finish.
‰ Using a small bladed screwdriver, tighten the setscrew to secure the escutcheon to the shower arm.
‰ Remove any excess sealant.
1491051-2-A
3 of 7
INSTALL THE SHOWERHEAD
Questions? Problems? For additional assistance, please contact KALLISTA's Customer
Raindome Showerhead
Service Department at 1-888-4-KALLISTA (1-888-452-5547) or kallista.com