KALLISTA P21435-00-CP Instrucciones De Instalación

INSTALLATION
INSTRUCTIONS
1. BEFORE YOU BEGIN
A. NOTES
This diverter can be used in either a deck-mount or
wall-mount installation. See Page 3 for special
wall-mount considerations.
Do not install spouts with flow restrictors or hand
held shower units on the large (5/8" O.D.) bath
outlet.
The two-way diverter is designed for use with
non-diverting bath spouts.
Carefully read the entire instruction before
beginning the installation; the illustrations do not
show all possible configurations.
B. ROUGHING-IN DIMENSIONS
Turn off the hot and cold water supplies.
Install or relocate the supply tubing to conform to the
roughing-in dimensions.
Deck-mount installation is shown. The same rough-in
dimensions apply to wall-mount installations.
1-1/2" D. HOLE
FOR DIVERTER
3"
FROM HOT VALVE
1/2" NOM. SWEAT (5/8" O.D.)
3/4" NPSM THREAD
F o r
A
1506311-2-
2-1/2" D.
2-3/8"
1-1/4" MAX.
TO BATH
1/2" NOM. SWEAT (5/8" O.D.)
1-5/16" D.
3/4" NPSM THREAD
FROM COLD VALVE
1/2" NOM. SWEAT (5/8" O.D.)
3/4" NPSM THREAD
t n V e i w
TWO-WAY DIVERTER
Provide an access panel for all installations.
Remove all internal components of the diverter
valve before
recommends soldering supply and optional outlet
connections to avoid potential leakage.
Observe all local plumbing and building codes.
WARNING: Risk of personal injury. This product
is a diverter valve only, and should never be used
as a shut-off valve. Use as a shut-off valve will allow
cross flow between the hot and cold water supplies,
and will create a serious scalding hazard.
S
Fig. #1
soldering. Kallista,
TO SHOWER/HANDSPRAY
3/8" NOM. SWEAT (1/2" O.D.)
1/2" NPSM THREAD
d i e V e i w
2022 KALLISTA
Inc.