Complete The Installation - Kohler K-528-K1 Instrucciones De Instalación

Ocultar thumbs Ver también para K-528-K1:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

5. Complete the Installation

NOTICE: Do not plug in the power cord until all digital interface cables are connected.
IMPORTANT! Make drip loops in all cables and cords.
NOTE: If an interface is not available, proceed to the "Installation Checkout" section, and "Test for Leaks without an
Interface."
Route the digital interface cable(s) in the wall from the valve location to the digital interface installation location(s).
If not already installed, install the digital interface(s) according to the instructions packed with the product.
Attach a split boot to each interface cable.
Connect the digital interface cable(s) to the valve.
Press the boot over the connection and into the valve socket. If only one digital interface is installed, insert a solid boot
into the unused socket.
Verify that there is power to the 120 V GFCI electrical outlet.
Plug the power cord into the electrical outlet.
Kohler Co.
Solid Boot
Split Boot
11
1145587-2-E

Publicidad

Tabla de contenido
loading

Tabla de contenido