Assembly; Assembly Components; Assembly Of The Guide Bar And Toothed Chain - Stiga CS 700 Li 48 Manual De Instrucciones

(fast battery charger); L2 (standard battery
charger).
M. Battery backpack (accessory on request.
par.15.4): device used to store batteries.
N. Connection cable: cable used to connect
the machine to the battery pack.
O. Battery simulator (accessory on request.
par.15.5): device that allows the use of
the battery backpack when inserted in the
machine housing.
P. Battery location: place where the battery is
inserted in the machine.

4. ASSEMBLY

The safety regulations to follow are
described in chap. 2. Strictly comply with
these instructions to avoid serious risks or
dangers.
For storage and transport purposes, some
components of the machine may not be installed
in the factory and have to be assembled after
unpacking. Follow the instructions below.
Unpacking and completing the assembly
should be done on a flat and stable surface,
with enough space for machine handling and
its packaging, always making use of suitable
equipment. Do not use the machine until all
the instructions provided in the "ASSEMBLY"
section have been carried out.

4.1 ASSEMBLY COMPONENTS

The packaging holds the components needed
for assembly as listed in the table below:
Guide bar fitted with bar cover
Toothed chain
Key
Documentation
4.1.1 Unpacking
1. Carefully open the packaging, paying attention
not to lose components.
2. Consult the documentation in the box,
including these instructions.
3. Remove all the unassembled parts from the
box.
4. Remove the machine from the box.
5. Dispose of the box and packaging in
compliance with local regulations.
4.2 ASSEMBLY OF THE GUIDE
BAR AND TOOTHED CHAIN
Always wear heavy duty gloves when
handling the bar and chain. Mount the bar
and chain very carefully so as not to impair
the safety and efficiency of the machine. If in
doubt, contact your dealer.
Perform all operations after removing
the battery.
Before assembling the bar, check that
the chain brake is not engaged (par. 5.4).
1. Using the supplied wrench, unscrew the
nuts (Fig. 3.A) and remove the chain guard
(Fig. 3.B), to access the drive pinion and bar
seat.
2. Mount the bar (Fig. 4.A) by inserting the stud
bolts (Fig. 4.B) in the groove (Fig. 4.C) and
push it towards the back of the machine body.
3. Make sure the chain tension adjuster
pin (Fig. 4.D) is correctly inserted in the
corresponding hole in the bar; otherwise use
a screwdriver to tighten the chain tension
adjuster screw (Fig. 4.E), until the pin is
inserted completely.
4. Tilt the machine to make it easier to wind the
chain around the drive sprocket (Fig. 5).
5. Mount the chain (Fig. 6.A) around the
drive sprocket (Fig. 6.B) and along
the bar guide (Fig. 6.C) being careful
to follow the sliding direction.
6. If the tip of the bar is equipped with a nose
sprocket, make sure the drive links are
correctly inserted in the sprocket rims (Fig. 7).
7. Refit the guard (Fig. 8.A), without fully
tightening the nuts.
8. Turn the chain tension adjuster screw (Fig. 9)
to achieve the desired tension (Fig. 10) (par.
6.1.3).
9. Raise the bar and tighten the guard nuts
securely using the wrench supplied (Fig. 11).
EN - 8
Direction in which
the chain runs