Worx WG708 Manual De Instrucciones página 12

mower.
c) Keep the area of operation clear of all
persons, particularly small children, and
pets.
d) Do not use a mower for any job except that
for which it is intended.
1.2 Preparation
a) Thoroughly inspect the area where the
equipment is to be used and remove all
stones, sticks, wires, bones, and other
foreign objects.
b) Do not operate the equipment when
barefoot or wearing sandals. Always wear
substantial footwear.
c) Disengage the self-propelled mechanism
or drive clutch on units so equipped before
starting the motor.
d) Never attempt to make a wheel height
adjustment while the motor is running.
e) Mow only in daylight or in good artificial
light.
f) Never operate the equipment on wet grass.
Always be sure of your footing. Keep a firm
hold on the handle and walk, never run.
1.3 Operation
12 12
a) Do not put hands or feet near or under
rotating parts. Keep clear of the discharge
opening at all times.
b) Stop the blade(s) when crossing gravel
drives, walks, or roads.
c) After striking a foreign object, stop the
motor, unplug, thoroughly inspect the
mower for any damage, and repair the
damage before restarting and operating
the mower.
d) If the equipment should start to vibrate
abnormally, stop the motor and check
immediately for the cause. Vibration is
generally a warning of trouble.
e) Stop the motor and unplug whenever you
leave the equipment, before cleaning the
mower housing, and before making any
repairs or inspections.
f) Shut the motor off and wait until the blade
comes to a complete stop before removing
the grass catcher or before unclogging the
chute.
g) Mow across the face of slopes, never up
and down. Exercise extreme caution when
changing direction on slopes. Do not mow
3-in-1 Lawn mower
All manuals and user guides at all-guides.com
h) Never operate the mower without proper
i) Do not wash with a hose, avoid getting
1.4 Maintenance
a) Check the blade and the engine mounting
b) Keep al nuts, bolts, and screws tight to
c) Check bag frequently for deterioration and
d) Replace the blade if it is bent or cracked.
e) Sharpen a dull blade equally at each end to
f) Clear the blade thoroughly and check its
SavE ThESE iNSTruCTioNS
excessively steep slopes.
guards, plates, or other safety protective
devices in place.
water in motor and electrical connections.
bolts at frequent intervals for proper
tightness.
be sure the equipment is in safe working
condition.
wear, and replace worn bags. Check that
replacement bags comply with the original
manufacturer's recommendations or
specifications.
An unbalanced blade causes vibration
that could damage the motor drive unit or
cause personal injury.
maintain the balance.
balance by supporting it horizontally on a
thin nail through its centre hole. The mail
should also be in a horizontal position. If
either end of the blade rotates downward,
remove some metal from the heavy or
lower end until the blade is balanced. It is
balanced when neither end drops.
EN