Adjusting The Cutting Height - Worx WG708 Manual De Instrucciones

3) Pick up the grass bag by the handle, and
position grass bag on the lower hooks (a) on
the mower deck (Fig. C2).
4) Release the safety guard to lock the grass
bag into position. Ensure the grass bag is
installed securely (Fig. C3).
NoTE: Depress the grass bag slightly to
ensure that it is completely installed.
4. rEmoviNG/EmPTyiNG
Hold the grass bag, lift the safety flap (9) and
hold up. Remove grass bag (4).
warNiNG! Always check the safety flap
can close the discharge outlet tightly
before using. Never lift the safety flap (9)
when the lawn mower is being used without
fitted grass bag.
5. haNdLE adJuSTmENT (See d)
The upper handle can be adjusted to 3
different height positions. Release the locking
cam lever, set the upper handle to one of the
three height positions, and make sure to insert
the pin into the hole. Then reset the locking
cam lever.
14 14
NoTE: Always check that the upper handle is
fixed firmly.
OPERATION
1. STarTiNG aNd SToPPiNG
(See E1, E2)
STarTiNG
Connect the plug to the mains and switch ON.
The switch box is provided with a lock-
off button to prevent accidental starting.
With one hand press and hold the safety
button (5), with the other hand squeeze the
switch lever (1) towards the handle, and
release the safety lock off button. The machine
is now started; wait until the product is at full
speed before cutting the grass. Then use both
your hands to hold the switch lever to keep it
running.
SToPPiNG
Release the switch lever. The lever is spring
loaded and will quickly return to the off
position upon release.
3-in-1 Lawn mower
All manuals and user guides at all-guides.com
2. iNSTaLLiNG muLCh iNSErT (See F)
1) unplug tool, and wait for blade to
come to a complete stop
2) Raise the safety guard and hold it up.
3) Slide the mulching insert (12) into the
discharge opening until it is firmly in contact
with the deck.
4) Release safety guard and ensure it is
properly closed.
3. rEmoviNG muLCh iNSErT (See F)
To remove the mulching insert so that you can
collect the grass follow the steps listed below:
1) unplug tool, and wait for blade to
come to a complete stop.
2) Raise the safety guard and hold it up.
3) Grasp the middle of the insert, lift and pull
out the mulching insert completely.
4) The safety guard is spring loaded. When you
release it, the guard will return to the closed
position.

4. adJuSTiNG ThE CuTTiNG hEiGhT

(See G)
come to a complete stop. the blades continue
to rotate after the machine is switched off, a
rotating blade can cause injury.
CauTioN: Do not touch rotating blades.
The lawn mower can be set to 6 cutting
heights between 1.5" (38mm)and 3.5"(88mm).
1. Your mower features the WORX one touch
cut height adjustment
2. Move the cutting height adjustment lever
outwards then adjust to the preferred position.
3. This system will adjust all four wheels at the
same time, up or down.
5. GraSS baG FiLLiNG iNdiCaTor
(See h)
To remind you immediately to empty when
the grass bag is full, the mower provides
an indicator on the top of bag to show the
collection status. And you can follow as
below:
Empty status: flap float (a)
warNiNG: Stop realease the swith
lever, unplug tool, and wait for blade to
EN