Power Switch - Peavey Architectural Acoustics AUTOMIX CONTROL 8 Manual Del Usuario

Rear Panel
22. LINK PORT
23. LINK SWITCH

24. POWER SWITCH

All manuals and user guides at all-guides.com
To increase the number of inputs available, multiple Automixers can be linked together.
Linking automixers is a very simple process. It can be done with a small flat-head
screwdriver and a short length of four conductor shielded wire. The following diagram and
procedures will ensure proper linking.
1. Make a linking cable.
2. Connect the mixers according to the diagram above.
3. Select the mixer to be used as the master and place its link switch in the "master"
position.
4. All other mixers in the system should have their link switches in the "slave" position.
You now have a 16 (or more) channel automatic mixer. The master controls of the unit
chosen as "master" should be used to control the system.
The link switch is used to place the unit in the master or slave mode of operation. A stand-
alone unit should always be in the master mode. See Link Port (#22).
Switch to "I" position to turn on.
12