Troubleshooting; Technical Specifications - GGP ITALY SV200 Manual De Instrucciones

8
EN

7. TROUBLESHOOTING

PROBLEM
a) Hard starting
b) Inconsistent
working
c) Loss of power
while mowing

8. TECHNICAL SPECIFICATIONS

8.1
REFILLING AND OPERATION MATERIALS
Fuel ............................................................................................ Ethanol E85 + 1% additive MTR-LIFE
Tank capacity .............................................................................................................................. 1.2 liter
Engine oil: from 5 to 35 °C......................................................................................................... SAE 30
from -15 to +5 °C .................................................................................... 5W-30 or 10W-30
from -25 to +35 °C .................................................................. Synthetic 5W-30 or 10W-30
Oil capacity ................................................................................................................................ 0.65 liter
Spark plug ......................................................................................... RN9YC (Champion) or equivalent
Spark plug gap ................................................................................................................... 0.6 - 0.8 mm
All manuals and user guides at all-guides.com
LIKELY CAUSE
- No fuel
- Old fuel or deposits in the fuel tank
- Spark plug disconnected
- Dirty electrodes or incorrect gap
- Air filter clogged
- Incorrect oil for the season
- Fuel has evaporated in the carburet-
tor (vapour lock) due to high temper-
atures
- Fault in carburation
- Hard starting
- Dirty electrodes or incorrect gap
- Air filter clogged
- Fault in carburation
- Hard starting
- Air filter clogged
- Fault in carburation
- Governor out of phase with respect
to the accelerator
SOLUTION
- Check and top up (see 5.1.3)
- Empty the fuel tank and add fresh
fuel
- Check that the spark plug cap fits
well over the plug terminals (see
5.1.4)
- Check (see 6.6)
- Check and clean (see 6.5)
- Replace with proper oil (see 6.3)
- Wait for a few minutes then start
again (see 5.3)
- Contact a Licensed Service Centre
- Contact a Licensed Service Centre
- Check (see 6.6)
- Check and clean (see 6.5)
- Contact a Licensed Service Centre
- Contact a Licensed Service Centre
- Check and clean (see 6.5)
- Contact a Licensed Service Centre
- Adjust the cable (see 6.7)
®