Operating The Unit; Charging Batteries - ProMed feeling Instrucciones De Empleo

O
PERATING THE UNIT
The power plug is intended as a separator. Make sure
that the power plug is plugged into an easily reachable
wall socket.
A. The appliance functions with and without power connection.
Before commissioning, put the adaptor (G) in the socket and
the adaptor connector plug (F) in the adaptor socket (E) for
power connectio The batteries must be charged before using
the appliance for the first time.

Charging batteries:

Do not recharge the batteries after each use. If the batteries are
not used for longer period, it should be first recharged, whenever
required. Plug the adaptor connector (F) into the adaptor socket
(E) on the appliance end and connect the adaptor (G) to the
mains supply. Charging of the batteries takes approx. 16 hours.
The LED-display (D) lights up to indicate that the charging is in
progress. On completion of charging, disconnect the charger
from the mains. Once the appliance starts turning slowly, this
All manuals and user guides at all-guides.com
B. Insert the required abrasive wheel into the relevant quick collet
C. Right/Left run
The direction of run must never be changed during the operation,
as the appliance can otherwise be damaged.
indicates that the battery must be charged.
(H) of the appliance. The appliance is now ready for operation.
The direction switch (C) for the right/left run is located above
the LED (D). The corresponding running direction is selected by
sliding this switch. The unit is in standby mode in the centre
position.
Note:
DE
EN
FR
IT
ES
NL
RU
PL
SE
FI