Correct Use - IKA ULTRA-TURRAX T 25 digital Instrucciones De Manejo

cause the speed is too high.
• Before switching on the dispersing instrument make sure that its
shaft is immersed min. 45 mm in the medium to prevent the
medium from splashing out.
• The distance between the dispersion tool and the vessel bottom
should not be less than 10 mm.
• In the event of unbalance or unusual noises, switch off the appli-
ance immediately. Replace the dispersing
difference after the change of the dispersing tool, return it to the
dealer or the manufacturer along with a description of the fault.
• Do not touch rotating parts during operation.
• Please note that the dispersing element and the journal bearings
can become extremely hot during use.
• Do not cover the ventilation slots on the drive in order to ensure
adequate cooling of the drive.
• Only process media that will not react dangerously to the extra
energy produced through processing. This also applies to any
extra energy produced in other ways, e.g. through light irradiation.
• Do not process any flammable or combustible materials.
• Process pathogenic materials only in closed vessels under a suitable
extractor hood. Please contact IKA if you have any questions.
•
Abrasion of the dispersion equipment or the rotating accessories
can get into the medium you are working on.
• Meter powder not too close to the flange. Powder can be blown
away by air turbulences of the drive.
• The appliance does not start up again automatically following a
cut in the power supply.
• The appliance can only be disconnected from the mains supply
by pulling out the mains plug or the connector plug.
• The socket for the mains cord must be easily accessible.
• Always disconnect the plug before fitting accessories.
• Safe operation is only guaranteed with the accessories described
in the "Accessories" chapter.
• Never run dispersion tools dry, as the gasket and bearings will be
destroyed if the tools are not cooled by the medium.
• The gasket and bearings are made of PTFE and rustproof steel;
the following points should therefore be noted: Chemical reac-
092007
All manuals and user guides at all-guides.com
element. If there is no
tions of PTFE occur in contact with molten or solute alkali metals
and alkaline earth metals, as well as with fine powders of metals
in groups 2 and 3 of the periodic system at temperatures above
300 °C - 400 °C. Only elementary fluorine, chlorotrifluoride and
alkali metals attack it; halogenated hydrocarbons have a reversi-
ble swelling effect.
(Source: Römpps Chemie-Lexikon and "Ulmann", Volume 19)

Correct use

Application
When used in combination with one of our recommended dispersing
elements, the drive unit is a high-speed dispersing and emulsifying
unit capable of handling free-flowing and liquid media in batches.
- Production of: Emulsions
Dispersions
Wet crushing
- Operating modes: on stand
Range of use
- Laboratories - Schools
- Pharmacies
The protection for the user is not ensured no more, if the equip-
ment with accessories is operated, which are supplied or are not
recommended not by the manufacturer or if the equipment in not
correct use is operated against the manufacturer default.
13