Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
1 On the generator control panel, connect the hose to the Propane inlet.
Apply a clamp (not included) to fix the hose correctly. Point 1 of the figure
below.
2 Connect the hose to the pressure regulating valve, fixing with a clamp (not
included). Point 2 of the figure below.
3 Apply the regulating valve to the propane cylinder. Point 3 of the figure
below.
NOTE: This figures shows the types of cylinders and regulators used in mainland
Spain. The types of cylinders and regulating valves can be different from country
to country. In any case, ensure a pressure of 30Mbar and a flow rate of 2.5k/h or
more.
Before using the generator, check if there are no leakages in the connections of
the propane hose. To do that, open the regulating valve in the cylinder so that the
hose can have pressure.
Then spray the hose connections with a mixture of soap and water. To do that,
use a sprayer. In case of leakage, bubbles will always be detected (even if small).
If there is no leakage, clean and dry the hose and its connections.
If you see or smell a leakage and you are unable to repair it, close the valve on the
cylinder regulator and contact a plumber or a gas installer. Thus, the connections
will be made correctly.
56
Publicidad
Tabla de contenido
