Beurer AS 50 Manual De Instrucciones página 16

Do not continue to turn the lid of the unit, if it cannot be
turned into the battery compartment without resistance.
This may damage the unit.
Batteries can contain toxins that are harmful to the envi-
ronment. Always dispose of batteries in accordance with
applicable local regulations. Do not dispose of batteries
with normal household waste.
This product contains a CR Type Coin Lithium Battery which contains
Perchlorate Material – special handling may apply:
See: www.dtsc.ca.gov/hazardouswaste/perchlorate
NOTE: It is recommended that the battery is changed in the morning
before recording the activity. This is the only way to ensure that the
daily recording is not overwritten in the PC software EasyFit.
At first remove the activity sensor from the belt clip (see chapter "8.3
Attaching the activity sensor", section "Wearing the activity sensor on
your belt/pants waistband").
The battery compartment of the activity sensor is located on the back
of the monitor. Place the monitor with the front facing downwards on a
soft surface and insert the battery as follows:
1 Using a coin, turn the lid of the battery com-
partment counterclockwise until the lid comes
off. Remove the battery from the battery com-
partment with the aid of a pointed, non-
metallic tool, e.g. toothpick.
2 Put the battery into the battery compartment
in such a way that the battery is on top of the
spring underneath the clip (1) and the positive
pole (+) faces upwards. Check the seal of the
battery compartment cover. The seal has to
lie flat in the battery cover and there must be
no visible damage to it. The impermeability
cannot be guaranteed otherwise.
All manuals and user guides at all-guides.com
14