Beurer AS 50 Manual De Instrucciones página 27

NOTE:
Pay attention to adjust the sensitivity of the device differently de-
pending on how it is attached. We recommend wearing the activity
sensor on your belt to get the most accurate results of the device
as possible!
Only change between belt clip and wristband if necessary. Changing
too frequently wears out the material of the wristband.
Wearing the activity sensor on your belt/pants waistband
You can attach your activity sensor to your belt or the top of your
shorts, pants or skirt with the supplied belt clip. To do this, put the
activity sensor into the belt clip as follows:
Put the casing into the belt clip. Pay
attention that the USB connector (1) is
fixed on the side of the clip with the
notch.
The casing has to be firmly and directly
attached to the belt clip, it must not be
loose. Otherwise there is a risk of the
device detaching itself and possibly
getting damaged or lost.
Removing the activity sensor from the
belt clip:
There is a small groove between the
belt clip and the activity sensor. Put
your fingernail carefully into this groove
and press slightly to separate the belt
clip and the activity sensor.
Do not pull on the buttons!
All manuals and user guides at all-guides.com
25