Exterior Maintenance; Service; Reasons For Operational Problems - Troubleshooting; Optional Equipment - Jotul F 100 Instrucciones Para Instalación

ENGlish
6.5 Checking the fireplace
Jøtul recommends that you personally check your fireplace
carefully after sweeping/cleaning. Check all visible surfaces
for cracks.
Also check that all joints are sealed and that the door and
top plate gaskets are in the correct position. Any gaskets
showing signs of wear or deformation must be replaced.
Thoroughly clean the gasket groove, apply ceramic glue
(available from your local Jøtul dealer), and press the gasket
well into place. The joint will dry quickly.
6.6 Exterior maintenance
Painted products may change colour after several years of
use. The surface should be cleaned and brushed free of any
loose particles before new Jøtul stove paint is applied.
Enamelled products must only be cleaned with a dry cloth.
Do not use soap and water. Any stains can be removed with
a cleaning fluid (e.g. oven cleaner).

7.0 Service

Warning! Any unauthorised change to the product is
illegal.
Only use original spare parts.
7.1 Replacement of the baffle plate
– inner bottom – burn plates
• Remove the ash retainer.
• Lift the baffle, which rests on the burn plates, forwards
and to the side and then tilt it down and out of the
door. (If the product is rear-mounted the top plate may
be lifted off and the baffle removed through the top.)
• Lift up the inner bottom and tilt it out.
• Remove the burn plates.
Follow the same procedure for installation, but in
reverse.
0
All manuals and user guides at all-guides.com
8.0 Reasons for operational
problems - troubleshooting
Poor draught
• Check the length of the chimney so that it covers
• Ensure that the minimum cross-section of the chimney
• Make sure that there is not anything preventing the
The fire extinguishes after a while
• Make sure that the wood is sufficiently dry.
• Find out whether there is negative pressure in the
• Check that the air vent is open.
• Check that the flue outlet is not clogged by soot.
If an unusual amount of soot accumulates on
the glass
Some soot will always stick to the glass, but the quantity
depends on:
• Humidity of the wood.
• The local draught conditions.
• Regulating the air vent.
Most of the soot will normally burn off when the air vent
is opened all the way and a fire is burning briskly in the
fireplace. See also «6.1 Cleaning of glass - good advice»
9.0 Optional equipment
Floor plate
For the Jøtul F 100 we can supply a decorative blue-black
enamelled floor plate.
Size: 630 x 759 x 17 mm.
Long legs
If you would like a taller fireplace it is possible to install
longer legs. Height 15 mm.
Extra heat shield - Cat. no. 350743
If the product is mounted with an extra heat shield, see
fig. 1 for distances from wall to stove.
the requirements stipulated in national laws and
regulations. See also «2.0 Technical data» and «4.5
Chimney and flue pipe» for information.
is in accordance with «2.0 Technical data»
flue gasses from escaping: Branches, trees, etc.
house, close mechanical fans and open a window close
to the stove.