Laying The Cables; Wiring Diagram; Connection Of Cable Set - Waeco MagicSafe MS150 Instrucciones De Montaje Y D’uso

MSK-150_09092003.qxd
Malfunction or damage to components is repeatedly caused by cables
not being laid or connected properly. Correct laying and connection of
cables is essential for long-term, fault-free functioning of retrofit
components.
Please note the following points:
- Always lay cables in such a way that they cannot be damaged. Never
lay them for example over sharp edges or next to hot or moving parts.
- Lay cables alongside original cable looms and connect them as
frequently as possible with insulating tape or cable binders.
- If cables have to be laid from the vehicle interior into the engine or
luggage compartment, use the existing cable passages through the
bulkheads.
Wiring diagram (see E)
Orange
Connect this wire to a switched power source like ACC terminal of the
ignition key.
This source is not allowed to drop on voltage during e.g. starting the
motor (terminal 15).
Yellow
Connect to any circuit that switches to earth when the bonnet is
opened. If no such circuit exists, fit an additional pin switch that
switches to ground signal when the bonnet is opened.
If you want to connect the door switches in parallel you have to use the
installation kit MSK-150SW in addition (see E).
16.03.2004 8:19 Uhr
All manuals and user guides at all-guides.com

Laying the cables

Wiring diagram

Connection of cable set

Seite 33
33