Teac LP-R500 Manual Del Usuario página 11

F TRACK INCREMENT
During recording, use this button to divide tracks.
G Display
H
Skip/Search (.m/,/), TUNING (
In CD mode, use these buttons to skip tracks.
Hold down these buttons to search for a part of a track.
In FM/AM mode, use these buttons to tune in a station.
I RECORD
Use this button to enter record pause mode.
J CD operation buttons
PLAY/PAUSE (y/J)
Use this button to start or pause playback and recording.
STOP (H)
Use this button to stop playback or recording.
K
Speakers (stereo)
L OPEN/CLOSE (L)
Use this button to open and close the disc tray.
M Remote Sensor
When operating the remote control unit, point it towards the
REMOTE SENSOR.
N VOLUME
Turn this knob to adjust the volume.
O Disc Tray
P REC LEVEL
In record pause mode, use this knob to adjust the recording level.
Q PHONES
For private listening, first reduce the volume level to minimum.
Then insert the plug from your headphones into the PHONES
jack, and adjust the volume by turning the VOLUME knob. The
sound from speakers will be cut off while the headphones are
plugged in.
< Do not turn the unit on or off, or insert or pull out the
headphones jack while wearing the headphones.
(Excessive sounds may occur from the headphones.)
< The sound from speakers will be cut off while the headphones
are plugged in.
R PROGRAM
In CD mode, use this button to program tracks.
S CLEAR
In CD mode, use this button to clear programmed tracks.
)
T REPEAT
In CD mode, use this button to select repeat mode of CD.
U DISPLAY
In CD mode, use this button to change the display.
V SHUFFLE
In CD mode, use this button for shuffle playback.
Note:
To simplify explanations, instructions refer to names of buttons
and controls on the front panel, making no mention of the use of
remote control unit.
11