Remote Control Unit; Battery Installation; Battery Replacement; Precautions Concerning Batteries - Teac LP-R500 Manual Del Usuario

Remote Control Unit

The provided Remote Control Unit allows the unit to be operated
from a distance.
When operating the remote control unit, point it towards the
REMOTE SENSOR on the front panel of the unit.
< Even if the remote control unit is operated within the effective
range, remote control operation may be impossible if there are
any obstacles between the unit and the remote control.
< If the remote control unit is operated near other appliances which
generate infrared rays, or if other remote control devices using
infrared rays are used near the unit, it may operate incorrectly.
Conversely, the other appliances may operate incorrectly.

Battery Installation

1
Remove the battery compartment cover.
2
Insert two "AA" (R6, SUM-3) dry batteries. Make sure that the
batteries are inserted with their positive "+" and negative "_"
poles positioned correctly.
3
Close the cover.

Battery Replacement

If the distance required between the remote control unit and
main unit decreases, the batteries are exhausted. In this case
replace the batteries with new ones.
For more information about collection of batteries, please
contact your local municipality, your waste disposal service or the
point of sale where you purchased the items.

Precautions concerning batteries

< Be sure to insert the batteries with correct positive "+" and
negative "_" polarities.
< Use batteries of the same type. Never use different types of
batteries together.
< Rechargeable and non-rechargeable batteries can be used. Refer
to the precautions on their labels.
< When the remote control unit is not to be used for a long time
(more than a month), remove the batteries from the remote
control unit to prevent them from leaking.
< If the batteries leak, wipe away the liquid inside the battery
compartment and replace the batteries with new ones.
< Do not use any other batteries not specified. Do not mix new
batteries with old ones or use different types of batteries
together.
< Do not heat or disassemble batteries and never throw them in
the fire or water.
< Do not carry or store batteries with other metallic objects. The
battery may short circuit, leak or explode.
< Never recharge a battery.

Basic Operation

1 Press the POWER switch to turn the unit on.
2 Select a source by pressing the corresponding button.
< To listen to an external source connected to AUX jacks, select
AUX by pressing the PHONO/TAPE/AUX button once or twice.
When PHONO/TAPE is selected, set the INPUT switch by the
turntable to "RECORD" or "TAPE".
3
Play the source, and adjust the volume by turning the
VOLUME knob.
13