Handle Adjustment; Installation With Base - Joie i-Juva Manual De Instrucciones

Handle Adjustment

see images -
3 4
The handle of the infant carrier
module can be adjusted to 3
positions.
3
!
Position 1- Position for car, hand or
stroller transportation.
Position 2- Rocking position.
Position 3- Baby chair position.
To adjust the handle, squeeze the
handle buttons on both sides to
-1
release it , and then rotate the
4
handle until it clicks into any of the 3
-2
positions.
4

Installation with base

see images -
5 15
1. Unfold the load leg from storage
compartment.
5
7
3
1
2
3
4
2
1
5
2. Fit the ISOFIX guides with the
ISOFIX anchor points.
6
The ISOFIX guides can protect the
surface of the vehicle seat from
being torn. They can also guide the
ISOFIX connectors.
3. Rotate the ISOFIX connectors 180
degrees until they are pointing in
the direction of the ISOFIX guides.
7
4. Line up the ISOFIX connectors with
the ISOFIX guides, and then
click both ISOFIX connectors into
the ISOFIX anchor points.
8
!
Make sure that both ISOFIX
connectors are securely attached
to their ISOFIX anchor points.
There should be two audible
clicks and the colors of the
indicators on the both ISOFIX
connectors should be completely
-1
green.
8
!
Check to make sure the base is
securely installed by pulling on
the both ISOFIX connectors.
6
7
8
1
8