PRESIDENT BILL II FCC Manual Del Usuario página 10

The channel is stored on the memory scan skip
Indicates the reception level and the output power
level
Emergency channel 1 (customizable) is activated
Emergency channel 2 (customizable) is activated
KEY LOCK function is activated
NB filter is activated
HI-CUT filter is activated
ANL filter is activated
SCAN function is activated
Indicates the frequency, the current menu,
Alert or the messages
Indicates current channel
5) CB/WX (WEATHER CHANNEL) ~ ALERT
CB/WX (WEATHER CHANNEL)
CB functions are not allowed in
a not allowed key and KEY BEEP function is activated,
the radio sounds error tone.
Press the CB/WX key (5) to
WX WX
mode is activated, "
mode. When
on the display.
WX
The mode allows to hear weather information. When
the mode is activated, use the s/t keys (3) on the unit
or the UP/DN keys on the microphone to
the 7 weather channels to find the active channel in your
local area (see WEATHER FREQUENCY TABLE page 71).
The display shows the selected weather channel and if
the unit receives a signal, "
for
(short press)
WX
mode. If user presses
alternate CB
between and
" appears
move through
" and " " icons blink.
ALERT
(long press)
The SIREN tone only sounds in
WX
in mode.
Long press the ALERT key (7), in order to
tivate the ALERT function. When the function is activat-
ed, is displayed. If a tone is detected at the selected
weather channel, then the unit sounds SIREN tone. The
CB
unit cancel mode and go to
During a SIREN tone sound, press PTT key (11) to stop the
sound.
6) ANL/NB ~ HI-CUT ~ SKIP
ANL/NB
(short press)
A short press on the ANL/NB key (6) allows you to
the following settings: no filter (default) / ANL activated
/ ANL and NB activated.
The icon of the active filter appears on the display.
NB: Noise Blanker / ANL: Automatic Noise Limiter. These
filters allow reducing back ground noises and some
reception interferences.
Warning: ANL filter works only in AM mode
HI-CUT
(long press)
Long press the HI-CUT key (6) to
HI-CUT filter. When the filter is activated "HI-CUT"appears
on the display.
HI-CUT: Cuts out the high frequency interferences and has
to be used in accordance with the reception conditions.
When active, the filter is displayed on display.
10
CB
mode. It does not sound
activate/deac-
WX
mode.
activate
activate/deactivate the