Trouble Shooting; How To Transmit Or Receive A Message - PRESIDENT BILL II FCC Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

- Power supply
- Dimensions inches
millimeters
- Weight
- Accessories supplied
2) TRANSMISSION
- Frequency allowance
- Carrier power
- Transmission interference
- Audio response
- Emitted power in the adj.
channel
- Microphone sensitivity
- Maximum drain
- Modul. signal distortion
3) RECEPTION
- Maxi. sensitivity at 20
dB sinad
- Frequency response
- Adjacent chan. selectivity : 60 dB
- Maximum audio power
- Squelch sensitivity
- Frequency image
rejection rate
- Intermediate frequency
rejection rate
- Drain
: 13.8 V
: 4.02 (W) x 3.94 (D) x 0.98 (H)
: 102 (W) x 100 (D) x 25 (H)
: ± 0.705 lbs / ± 0.320 kg
: Electret microphone with
support, mounting cradle,
quick fixation clip, screws.
: +/- 200 Hz
: 4 W AM / 4 W FM
: inferior to 4 nW (- 54 dBm)
: 300 Hz to 3 KHz
: inferior to 20 µW
: 5.5 mV (elec.) / 2.2 mV (dyn.)
: 2 A
: 2 %
: 0.5 µV - 113 dBm - AM
: 0.3 µV - 116 dBm - FM
: 300 Hz to 3 kHz
: 2.5 W
: minimum 0.2 µV - 120 dBm
maximum 1 mV - 47 dBm
: 60 dB
: 70 dB
: 150 ~ 700 mA
G) TROUBLE SHOOTING
1) YOUR CB RADIO WILL NOT TRANSMIT OR YOUR
TRANSMISSION IS OF POOR QUALITY
-
Check that the antenna is correctly connected and that
the SWR is properly adjusted.
-
Check that the microphone is properly plugged in.
-
You are using the same modulation mode as your cor-
respondent AM or FM.
2) YOUR CB RADIO WILL NOT RECEIVE OR RECEP-
TION IS POOR
-
Check that the squelch level is properly adjusted.
-
Check that the volume is set to a comfortable listening
level.
-
Check that the antenna is correctly connected and that
the SWR is properly adjusted.
-
You are using the same modulation mode as your cor-
respondent AM or FM.
3) YOUR CB WILL NOT LIGHT UP
-
Check the power supply.
-
Check the connection wiring.
-
Check the fuse.
H) HOW TO TRANSMIT OR RECEIVE A MESSAGE
Now that you have read the manual, make sure that your
CB Radio is ready for use (i.e. check that your antenna
is connected).
Press the «push-to-talk» PTT switch (11) and announce your
16

Publicidad

Tabla de contenido
loading

Tabla de contenido