Installation - PRESIDENT BILL II FCC Manual Del Usuario

Welcome to the world of the new generation of CB
radios. The new PRESIDENT range gives you access to
top performance CB equipment. With the use of up-to-
date technology, which guarantees unprecedented
quality, your PRESIDENT BILL II FCC is a new step in
personal communication and is the surest choice for
the most demanding of professional CB radio users.
To ensure that you make the most of all its capacities,
we advise you to read carefully this manual before
installing and using your PRESIDENT BILL II FCC.
A) INSTALLATION
1) WHERE AND HOW TO MOUNT YOUR MOBILE CB
RADIO
a) You should choose the most appropriate setting from a
simple and practical point of view.
b) Your CB radio should not interfere with the driver or the
passengers.
Diagram 1
c) Remember to provide for the passing and protection of
different wires (e.g. power, antenna, accessory cabling)
so that they do not in any way interfere with the driving
of the vehicle.
Mounting with the cradle
d) To install your equipment, use the cradle (1) and the
self-tapping screws [2] provided (drilling diameter 3.2
mm). Take care not to damage the vehicle's electrical
system while drilling the dash board.
e) Do not forget to insert the rubber joints (3) between the
CB and its support as these have a shock-absorbing
effect which permits gentle orientation and tightening
of the set.
f) Choose where to place the microphone support and
remember that the microphone cord must stretch to the
driver without interfering with the controls of the vehicle.
5
Mounting diagram
(diagram 1)