Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Reversing the opening direction of the doors
Required tools: Flat screwdriver, cross screwdriver, flat key.
Make sure the appliance is unplugged and empty.
•
To remove the door, you first need to tilt the appliance backwards. Lean the appliance against a
•
hard surface to prevent it from slipping during the operation.
•
All the parts removed must be kept to refit the door.
Do not lay the appliance down on the floor as this may damage the cooling system.
•
Ideally, the appliance should be handled by 2 people during the operation.
•
16.
Remove the screws from the top hinge cover and remove the hinge. Install the connecting wire
in the hole on top of the refrigerator.
.
17.
Unscrew the three bolts from the top hinge, remove the hinge and remove the cover, the door
sleeve and the magnet
18.
Insert the door connecting wire in the hole in the door, then cover it.
19.
On the top left-hand side of the refrigerator, remove the three bolts from the hinge cover. Then
remove the cover, take the cable harness out of the hole and install the sleeve on the door.
Publicidad
Tabla de contenido
