Champion Global Power Equipment 500559-EU Manual Del Operador página 18

500559-EU - 2800W RATED PORTAbLE GENERATOR
6. Gently the starter cord slowly until resistance is felt.

By rigorously pulling the recoil cord and not following the
correct practice you will damage the cord or mechanism
and void any part warranty.
7. As soon as engine starts, move the choke to the "RUN"
position over a 2-5 second duration.
8. Connect electrical loads.

Keep choke in "CHOKE" position for only 1 pull of the recoil
starter. After first pull, move choke to "RUN" position for
up to 3 pulls of the recoil starter. Too much choke leads to
spark plug fouling/engine flooding due to lack of incoming
air. This will cause the engine not to start.
NOTICE
NOTICE
For petrol restarts with hot engine in hot ambient
temperature > 86°F (30°C), keep choke in 75% of the
"CHOKE" position for only 1 pull of the recoil starter. After
first pull, move choke to "RUN" position for up to 3 pulls
of the recoil starter. Too much choke leads to spark plug
fouling/engine flooding due to lack of incoming air. This will
cause the engine not to start.
For gas starting in cold ambient temperature < 59°F
(15°C), the choke must be in 100% of the "CHOKE" position
for recoil start procedures. Do not over-choke. As soon as
engine starts, gradually move the choke lever to the "RUN"
position over a 2-5 second duration.
If the engine starts but does not run make certain that the
generator is on a flat, level surface. The engine is equipped
with a low oil sensor that will prevent the engine from
running when the oil level falls below a critical threshold.
Connecting Electrical Loads
Let the engine stabilize and warm up for a few minutes after
starting.
Plug in and turn on the desired 220 Volt AC single phase, 50 Hz
electrical loads.
– DO NOT connect 3-phase loads to the generator.
– DO NOT overload the generator.
– NEVER use both 220V or DC12V together they MUST be
used separately.
Connecting a generator to your electric utility company's power
lines or to another power source may be against the law. In
addition this action, if done incorrectly, could damage your
generator and appliances and could cause serious injury or even
death to you or a utility worker who may be working on nearby
power lines. If you plan to run a portable electric generator
during an outage, please notify your electric utility company
immediately and remember to plug your appliances directly into
the generator. Do not plug the generator into any electric outlet
in your home. Doing so could create a connection to the utility
company power lines. You are responsible for ensuring that your
generator's electricity does not feed back into the electric utility
power lines.
If the generator will be connected to a building electrical system,
consult your local utility company or a qualified electrician.
Connections must isolate generator power from utility power
and must comply with all applicable laws and codes.
18
OPERATION
NOTICE

NOTICE

NOTICE

WARNING
