Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
4
4.1
Notes on safety for the installation
After carefully cleaning all around the area where the burner will be installed, and arranging the correct lighting of the environment,
proceed with the installation operations.
All the installation, maintenance and disas-
sembly operations must be carried out with
the electricity supply disconnected.
DANGER
4.2
Handling
The packaging of the burner includes a wooden platform, so it is possible to move the burner (still packaged) with a transpallet truck or
fork lift truck.
The handling operations for the burner can be highly dangerous if not carried out with the greatest attention: keep any
unauthorised people at a distance; check the integrity and suitableness of the available means of handling.
Check also that the area in which you are working is empty and that there is an adequate escape area (i.e. a free, safe
WARNING
area to which you can quickly move if the burner should fall).
During the handling, keep the load at not more than 20-25 cm from the ground.
After positioning the burner near the installation point, correctly dispose of all residual packaging, separating the various
types of material.
Before proceeding with the installation operations, carefully clean all around the area where the burner will be installed.
CAUTION
4.3
Preliminary checks
Checking the consignment
After removing all the packaging, check the integrity of the contents. In the event of doubt, do not use the burner; contact
the supplier.
CAUTION
The packaging elements (wooden cage or cardboard box, nails, clips, plastic bags, etc.) must not be abandoned as they
are potential sources of danger and pollution; they should be collected and disposed of in the appropriate places.
Checking the characteristics of the burner
Check the identification label of the burner, showing:
the model (see A in Fig. 8) and type of burner (B);
the year of manufacture, in cryptographic form (C);
the serial number (D);
the data for electrical supply and the protection level (E);
the electrical input power (F);
the types of gas used and the relative supply pres-
sures (G);
the data of the burner's minimum and maximum output
possibilities (H) (see Firing rate)
Warning. The burner output must be within the boiler's
firing rate;
the category of the device/countries of destination (I).
The installation of the burner must be carried
out by qualified personnel, as indicated in this
manual and in compliance with the standards
WARNING
and regulations of the laws in force.
R .B.L.
D
G AS-K AASU
G AZ-AE P IO
Fig. 8
D7738
A burner label that has been tampered with, re-
moved or is missing, along with anything else
that prevents the definite identification of the
WARNING
burner and makes any installation or mainte-
nance work difficult.
11
GB
A
B
E
G
G
R IE LL O S .p.A .
I
I-37045 L egna go (V R )
C E
0085
C
F
H
H
20133205
Publicidad
Tabla de contenido
