Selecting An Operating Mode - Uline H-3448 Guia De Inicio Rapido

LOADING PAPER ROLL
Loading the dispenser with a stub roll
1. When the main roll is approximately 2.6" in diameter
(60' remaining) the stub roll light will come on. At that
time and without disengaging the paper sheet, move
the stub roll to the lower roll holders. (See Figure 4)
Figure 4
Stub Roll
2. Load the new towel roll into the upper roll holders so
that the paper feeds down from the back.
3. Lift the transfer bar.

SELECTING AN OPERATING MODE

The dispenser is designed to function in either "Hidden"
or "Hang" mode. (See Figure 6)
1. To Select "Hidden" mode, slide the switch
to the Hidden Mode icon. In this mode,
a sheet will be dispensed when a hand
is detected under the dispenser.
2. To select "Hang" mode, slide the switch
to the Hang Mode icon. In this mode,
a sheet is already hanging out of the
dispenser. Each time the sheet is torn,
another will automatically dispense.
NOTE: It is recommended that the activation
sensitivity switch be set to High (switch
fully down) when in "Hang" mode, unless
the installation is over a counter or trash
receptacle. For installation over counters, trash
receptacles, etc., the activation sensitivity
switch must be set on the Low (switch fully up)
position.
PAGE 2 OF 12
OPERATION CONTINUED
.
OPERATION AND FEATURES
Hidden Mode
Hang Mode
4. Place the leading edge of the paper under the
transfer bar and on top of the existing paper sheet.
Release the transfer bar.
5. Wrap the leading edge of
the paper up and around
the transfer bar and
puncture the paper with
the transfer tab so that the
paper is held in place.
(See Figure 5)
6. Leave some slack in the
main roll to ensure proper
transfer.
7. Firmly close dispenser.
8. The stub roll will continue
to dispense paper until the
last 15 feet, at which time
the main roll will begin to
feed. During this transition
both rolls will feed paper
until the stub roll is empty.
Activation
Sensitivity
Adjustment
Figure 5
Detail of Transfer Tab
Figure 6
Operation
Mode
Selection
0721 IH-3448