Care And Cleaning - geberit SIGMA10 Instructions De Montage

4
If required, install the Geberit App and make
a note of the pairing secret for the new
control.
5
Plug in both cables and mount the actuator
plate. → See figure sequence
6
Test function. → See "Actuate manual
flush", page 26.
7
Make settings using the Geberit App, if
required.
9007203771121035 © 04-2022
970.755.00.0(00)
Replacing the lifting device
1
2
3
4
5
6
7

Care and cleaning

ATTENTION
Surface damage caused by aggressive and
scouring cleaning agents
▶ Never use cleaning agents that contain chlorine
or which are acidic, abrasive or corrosive.
To clean the actuator plate, the flush actuation can
be suppressed for a few minutes using a Geberit
app.
3 , page 576.
1
2
Demount the actuator plate and unplug the
cable. → See figure sequence
Demount the mounting frame and protection
plate. → See figure sequence
Remove the lifting device and dispose of it
appropriately.
Mount the new lifting device.
Mount the protection plate and mounting
frame.
Plug in both cables and mount the actuator
plate. → See figure sequence
Test function. → See "Actuate manual
flush", page 26.
Geberit recommends the Geberit
AquaClean cleaning set (art. no.
242.547.00.1).
Clean the surfaces with a soft cloth and a
mild liquid cleaning agent.
Dry the surfaces with a soft cloth.
EN
1 , page 573.
2 , page 573.
3 , page 576.
29