Tabla de contenido
Publicidad
EN
4
Mount new actuator plate. → See figure
sequence
5
Put the WC flush control into operation: Step
more than 2 m away from the actuator plate.
✓ As soon as the control has detected the
environment, the actuator buttons flash
three times. The WC flush control is
ready for operation.
6
Test function: Step closer than 1.5 m in front
of the actuator plate.
✓ The actuator buttons light up.
7
To actuate a full flush, hold your hand in
front of the long actuator button on the left.
8
To actuate a partial flush, hold your hand in
front of the short actuator button on the right.
9
Make settings using the Geberit App, if
required.
Replacing the lifting device
The process is exactly the same for the Geberit
Sigma concealed cisterns 12 cm and 8 cm.
1
Demount the actuator plate. → See figure
sequence
2
Demount the mounting frame, protection
plate and lifting device. → See figure
sequence
3
Dispose of the defective lifting device appro-
priately.
4
Mount the lifting device, protection plate and
mounting frame. → See figure sequence
page 686.
5
Mount the actuator plate. → See figure
sequence
6
Put the WC flush control into operation: Step
more than 2 m away from the actuator plate.
✓ As soon as the control has detected the
environment, the actuator buttons flash
three times. The WC flush control is
ready for operation.
7
Test function: Step closer than 1.5 m in front
of the actuator plate.
✓ The actuator buttons light up.
36
4
, page 687.
1
, page 684.
2
, page 685.
4
, page 687.
8
To actuate a full flush, hold your hand in
front of the long actuator button on the left.
9
To actuate a partial flush, hold your hand in
front of the short actuator button on the right.
Care and cleaning
ATTENTION
Surface damage caused by aggressive and
scouring cleaning agents
▶ Never use cleaning agents that contain chlorine
or which are acidic, abrasive or corrosive.
Geberit recommends the Geberit
AquaClean cleaning set (art. no.
242.547.00.1).
To clean the actuator plate, the flush actuation can
be suppressed for a few minutes using a Geberit
app.
1
Clean the surfaces with a soft cloth and a
mild liquid cleaning agent.
2
Dry the surfaces with a soft cloth.
3
,
9753440651 © 04-2022
970.779.00.0(00)
Publicidad
Tabla de contenido
