Bosch GBH18V-28DC Instrucciones De Funcionamiento Y Seguridad página 13

2610056669 GBH18V-28DC 08-21_GBH18V-26D 8/30/21 9:19 AM Page 13
Depth Gauge
Your drilling depth can be pre-set and/or
repeated by using the depth gauge.
Setting depth: After the auxiliary handle
is installed, make sure the accessory has
been fully inserted into the tool holder
before setting the depth gauge (Fig. 10).
To adjust depth, push the depth gauge
release button, slide the depth gauge to
desired depth and release pressure on
button to lock the depth gauge in place.
Variable Speed Controlled
Trigger Switch
Your tool is equipped with a variable
speed trigger switch. The tool can be
turned "ON" or "OFF" by squeezing or
releasing the trigger. The speed can be
adjusted from the minimum to maximum
nameplate RPM by the pressure you
apply to the trigger. Apply more pressure
to increase the speed and release
pressure to decrease speed (Fig. 1).
discontinue use of the tool if the
variable speed control ceases to
function. Subsequent loss of on/off
control of the trigger switch is likely.
Forward/Reversing Lever
and Trigger Lock
until the tool comes to a complete
stop. Shifting during rotation of the
chuck can cause damage to the tool.
Your tool is equipped with a forward/
reversing lever and trigger lock located
above the trigger (Fig. 11). This lever
was designed for changing rotation of
the chuck, and for locking the trigger in
an "OFF" position to help prevent
accidental starts and accidental battery
discharge.
For forward rotation, (with chuck
pointed away from you) move the lever
to the far left. For reverse rotation move
the lever to the far right. To activate
trigger lock move lever to the center off
position.
Operating Instructions
To reduce the risk of
injury immediately
Do not change
direction of rotation
-13-
FIG. 10
DEPTH
GAUGE
DEPTH G UGE
RELE SE BUTTON
FIG. 11