Whirlpool W11581317 Hoja De Instrucciones página 10

4. Reach under the drum, (raise it as far as it will go), and push
the idler pulley arm, on the back of the drive motor, to the
left to relieve the tension on the belt, then remove the belt
from the pulley.
5. Slide the belt off the front of the drum and remove belt.
6. Lift the drum and remove it from the dryer cabinet.
Reassembly Note - Belt Orientation on Pulley
A. Idler Pulley
NOTE: Viewed from Rear of the Dryer
Section 3 - Gas Valve Conversion
Changing the Orifice (Both Styles)
Figure 1 - Gas Valve on the Right Side
A. Burner Tube
B. Gas Valve Assembly
C. Pressure Tap Plug
D. Screws
E. Ignitor
10
B. Drum Belt