Disconnecting the Drum Light and
Moisture Sensor
To Disconnect the Drum Light
1.
Unplug connector J6 from the ACU.
To Disconnect the Moisture Sensor
1.
Disconnect Moisture Sensor connector.
Removing the Belt and Drum
1. Remove the lint screen from the outlet grill then, Remove two
(2) 1/4" hex-head screws from the top of the console bracket
and two (2) from the front of the bracket. Remove console
bracket and set aside for reinstallation.
2.
Remove the three (3) 1/4" hex-head screws from the lint
duct and one (1) 1/4" hex head screw from the mounting
clip.
Swivel the lint duct down from the bulkhead and remove.
A.
B.
5
Screw on Mounting Clip
Screws on Lint Duct