Removing The Door - Whirlpool W11581317 Hoja De Instrucciones

5. Gently lift up on the four (4) console tabs. Separate console
assembly from bracket while routing the HMI harness
through the opening in the console bracket.

Removing the Door

Round Shaped Doors With Electrical Wiring
®
1. Using a T25 screwdriver, remove the four (4) screws
securing the door hinge to the dryer and lift the door up and
out to remove. See below figures. Place the door on a soft
towel or other non-scratch surface.
2. Now you can access the wiring connector (on some models).
3