Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3. Depress the console clip with the putty knife and lift up on the
console to separate from top panel. Tilt console forward for
service.
To Remove the Top Panel
1. Remove the three (3) Torx T20 1/4" hex-head screws from rear
bracket.
2.
Disconnect harness from ACU before removing top panel.
From the front of the unit push in on top panel and lift up
and away from dryer to remove.
Removing the Front Panel and Door
Switch
1.
Remove the two (2) Torx T20 screws.
2.
Disconnect the door switch connector.
3. Remove four (4) 1/4" hex-head screws from the bottom of the
front panel. See below figure.
8
Publicidad
Tabla de contenido
