Removing the Front Panel and Door
Switch
1.
Disconnect the door switch "inline" connector.
2.
Remove four (4) 1/4" hex-head screws from the bottom of
the front panel.
3.
Open dryer door and remove the lint screen. Next, remove
the two (2) Phillips screws below the dryer door.
4.
Remove the three (3) 1/4" hex-head screws from the top of
the front panel as shown in below figure.
5.
Lift the front panel assembly up off the tabs and away from
the dryer. Route the door switch harness around the front
console bracket.
4