Troubleshooting Guide - babymoov Handy Care Instrucciones De Uso

Problem
No sound on the receiver
Transmission always on
Audible alarm
permanently activated
Always showing low battery alert
Battery life is short
Communication is frequently
interrupted or off
The transmitter range is too short
• Frequency: 2.4 gHz
• Maximum output power: 19 dBm
• Battery: Li-Ion Battery Polymer 3.7 V / 750 mAh
6
TROUBLE SHOOTING GUIDE
Causes possibles
• The microphone's sensitivity is too low.
• The receiver volume is too low.
• The power adapter is not properly connected.
• SLEEP technology activated.
• The batteries are empty.
• The sensitivity of the «SLEEP» technology is too high.
• CONTINUOUS mode is activated.
• Transmitter battery is run down.
• Distance between baby and parent unit exceeds
the operating range.
• Battery has run down.
• The battery is damaged or empty.
• Night light is permanently switched on.
• CONTINUOUS mode is activated.
• The transmitter and/or receiver are located near
other electrical appliances.
• Using the babyphone on a power strip.
• The two appliances are separated by metal
structures, thick walls, floors, etc.
• Baby unit battery has run down.
• The two appliances are separated by metal
structures, thick walls, floors, etc.
• Baby unit battery has run down.
HANDY CARE
Solution
• Increase the microphone sensitivity.
• Increase the receiver volume.
• Check the connection.
• Press a button to activate the receiver.
• Charge your receiver or replace the batteries in the
transmitter or plug the units into the mains.
• Reduce the sensitivity of the SLEEP mode (2).
• Activate SLEEP technology using the button (5).
• Replace the batteries in the transmitter or plug the
transmitter into the mains.
• Move the receiver & the transmitter closer together.
• Replace with new battery or use AC adapter (transmitter).
• Recharge battery using AC adapter (receiver).
• Replace with new battery pack.
• Turn off the night light or adjust the SLEEP mode.
• Move the transmitter and/or receiver away from sources
of interference or re-set the pairing.
• Do not connect your baby monitors to power strips.
• Re-locate transmitter or receiver.
• Replace with new battery or use AC adapter.
• Re-locate baby or parent unit.
• Replace with new battery or use AC adapter.