Publicidad
Idiomas disponibles
Idiomas disponibles
support@nextlevelracing.com
31b
Install 2 x T-Nuts into the top channel and 2 x T-Nuts into the bottom channel of the Shifter Arm.
INSIDE VIEW
OUTSIDE VIEW
31c
Install 2 x T-Nuts into the top inner channel of the Shifter Arm.
always have 4 x T-Nuts installed to allow instal-
32
Align the T-Nuts previously installed into the Shifter Arm in Step 31b with the holes on the upper shifter arm bracket previously
installed in Step 30. Bolt through and secure using 2 x M8 Bolts and Washers.
PARTS:
• • 4 x T-Nuts
PARTS:
• • 2 x T-Nuts
PARTS:
• • 2 x M8 16mm Bolts
• • 2 x M8 Washers
Note: The outside of the shifter arm should
lation of the Tool Kit Holder.
22
33
Align the T-Nuts previously installed into the Shifter Arm in Step 31b with the holes on the bottom Shifter Arm Bracket
previously installed in Step 29. Bolt through and secure using 2 x M8 Bolts and Washers.
34a
34a
Align the curved slots on the Shifter Plate with T-Nuts previously installed in Step 31a & Step 31c. Bolt
through and secure with 4 x M8 Bolts and Washers.
)
)
A
B
34b
A) Loosen the Bolts securing the Shifter Arm Brackets to the Vertical Posts. Adjust to your desired height and distance.
B) Loosen the Bolts securing the Shifter Plate and adjust the assembly to your desired angle. Tighten the Bolts to lock
the Shifter assembly in position.
Video Instruction: bit.ly/nlrbuild
PARTS:
• • 2 x M8 16mm Bolts
• • 2 x M8 Washers
PARTS:
Repeat
on Other
• • 1 x Shifter Plate
Side
• • 4 x M8 16mm Bolts
• • 4 x M8 Washers
PARTS:
• • NIL
23
23
Publicidad
