Next Level Racing GT ELITE Manual De Instrucciones página 7

support@nextlevelracing.com
Note: Height of the foot can be adjusted only
when it's installed on to the cockpit.
05
Slide 4 x T-Nuts into the bottom channels of the Base Assembly as shown.
06
Align the NLR Height Adjustable Foot with the
T-Nuts previously installed in Step 05.
Note: Foot alignment tab
should sit in the channel.
08
Align the tab on the NLR Height Adjustable Foot
with the extrusion channel.
PARTS:
• • 4 x T-Nuts
• • 4 x Adjustable Feet
07
Install the NLR Height Adjustable Foot into T-Nuts
previously installed in Step 05.
09
Tighten the screw inside the NLR Height Adjust-
able foot with an Allen Key. Install Rubber Plug.
12
)
A
Note: Recess holes to
be on outside.
(R)
(L)
Note: Parts are labelled for
left and right side application
(L)
10
A) Align the threaded holes on the Upright Connection Plates with the holes on the Vertical Posts.
B) Bolt through and secure with 8 x M8 Bolts and Washers.
( )
FRONT
( )
BACK
11 Align the Right Vertical Post assembly with the T-Nuts previously installed in Step 01b. Bolt through
and secure with 4 x M8 Bolts and Washers.
( )
FRONT
( )
REAR
12
Align the Left Vertical Post assembly with the T-Nuts previously installed in Step 01a. Bolt through and
secure with 4 x M8 Bolts and Washers.
13
Video Instruction: bit.ly/nlrbuild
PARTS:
• • 2 x Upright Connection Plates
)
B
• • 8 x M8 35mm Bolts
(R)
• • 8 x M8 Washers
PARTS:
• • 4 x M8 20mm Bolts
• • 4 x M8 Washers
PARTS:
• • 4 x M8 20mm Bolts
• • 4 x M8 Washers