Publicidad
Idiomas disponibles
Idiomas disponibles
support@nextlevelracing.com
ALUMINIUM EXTRUSION TIPS
•
Please do not use power tools for assembly as over tightening can damage your frame.
•
Please ensure T-Nuts are correctly placed within the extrusion.
•
Lay out and build the cockpit on a level surface.
•
Do not force parts together.
•
Avoid cross threading bolts.
•
If you require further support, consult the installation video or contact us at support@nextlevelracing.com
•
The GTElite is a two person build with the complete cockpit a two person move.
•
Beware of sharp edges on the extrusion pieces.
Install cable clips at the location you would like them
during the build. Leaving the installation of cable clips
to the end can present installation issues. Depress the
alignment tab at the back during installation.
ANGLE
HEIGHT
DISTANCE
8
8
LEFT
REAR
IMPORTANT: Place T-Nuts as shown in diagram below on the OUTSIDE of Left Base
(Red dots are T-Nut placement)
Note: Slide 4 x T-Nuts
Note: Slide 2 x
T-Nuts to front for
to middle for Wheel
Post
Pedal Support
FRONT
01a
Slide 8 x T-Nuts into the outside channels of the Left Base Member.
Video Instruction: bit.ly/nlrbuild
Note: For easier installation hand
screw M8 Bolt in to T-Nut to assist
sliding T-Nut in to channel.
FRONT
RIGHT
Note: Slide 2 x
T-Nuts to rear for
Seat Sliders
BACK
9
9
Publicidad
