Uline Shark Rotator Lift-Away Manual Del Usuario página 9

OPERATING ISSUE
Vacuum is not picking
up dirt. No suction or
light suction.
Vacuum lifts area rugs.
Brush roll does not spin.
Vacuum turns off on
its own.
If the troubleshooting section does not resolve your problem, contact Uline Customer Service at 1-800-295-5510.
PAGE 9 OF 27
TROUBLESHOOTING
CAUSES
Dust cup may be full.
Filters may need cleaning.
Hose may be blocked.
The suction release on the
handle may be open.
Suction is too powerful for type
of rug: area rug or rug with
delicately sewn edges.
Brush roll needs to be
disengaged.
The auto-off feature may be
engaged.
There may be a blockage in
the bottom of floor nozzle or
brush roll.
Vacuum is equipped with a
motor protective thermostat.
If vacuum overheats, the
thermostat will automatically
turn the unit off.
1-800-295-5510
uline.com
RECOMMENDATIONS
Empty dust cup.
Check filters to see if they need cleaning.
Follow instructions for rinsing and drying
the filters before re-inserting back into the
vacuum.
Check hose, hose connections, nozzles
and accessories for blockages; clear
blockages if required.
Close the suction release on the handle
to increase suction power.
Open the suction release on the handle
to decrease suction power.
Turn off the unit to disengage the brush
roll and restart with the POWER button for
suction-only cleaning.
Pull handle toward you and release floor
nozzle to disengage the auto-off feature.
Turn unit on by pressing the BRUSH ROLL
button.
Immediately turn off and unplug vacuum,
disconnect the nozzle and remove
blockage before reconnecting and
turning vacuum back on.
To restart the thermostat:
1. Turn the unit off.
2. Unplug the vacuum.
3. Empty the dust cup and clean filters.
4. Check for blockages in hose,
accessories and inlet openings.
5. Allow the unit to cool for a minimum of
45 minutes.
6. Plug in the vacuum.
7. Restart the unit using either the POWER
or BRUSH ROLL button.
0622 IH-10108