Makita GEC01 Manual De Instrucciones página 15

7. Push in the shaft lock button and hold it to lock
the large pulley, and then turn the small disc clockwise
using the thick end of the box wrench to tighten the belt.
Fig.25
► 1. Shaft lock button 2. Large pulley
NOTE: Make sure that the small disc is in the position
shown in the figure.
Fig.26
► 1. Small disc
8.
large pulley, and then turn the nut clockwise using the
thin end of the box wrench.
1
2
Fig.27
► 1. Shaft lock button
NOTE: When tightening the nut, apply 19 - 21 N•m as
tightening torque.
9.
bolts using the tip of the box wrench.
Fig.28
► 1. Box wrench 2. Hex socket bolt 3. Cover
1
15 ENGLISH
Push in the shaft lock button and hold it to lock the
Attach the cover, and then tighten the hex socket
1
1
2
3