Installing The Rear Remote Controller (Optional) - Thermo King SL Manual De Instrucciones

NOTE: Verify mounting location and all dimensions before installing the
remote controller.
DANGER: Do not route electrical harness together with fuel lines as
this could cause a fire resulting in death or serious injury!
CAUTION: Do not drill holes into refrigeration, electrical or
mechanical components or severe damage to the equipment will
result!
Preferred Wire Routing (Steps 1, 2, 6-10)
NOTE: The preferred routing of the electrical harness chase and interface
harness is from the bottom of the controller box.
1. Connect the harness chase to the bottom of controller while providing a drip loop.
2. Install and route a 1/2 in. CPVC drain hose from the bottom of the controller box out
of trailer floor.
Alternative Wire Routing (Steps 3-10)
NOTE: The alternative routing of the electrical harness chase and interface
harness is from the side of the controller box.
3. Drill an appropriate size hole in the controller box for the harness chase coupling.
Installing the Rear Remote Controller
(Optional)
Foamed-In-Place Installation
4. Install harness chase coupling.
NOTE: Coupling should not protrude more than 6.4 mm (.25 in.) inside the
controller box.
5. Install cap in bottom of controller box before foaming trailer wall.
6. Apply chalking to controller box and install securely into trailer wall.
7. Apply Superlube (or equivalent) to interface harness connector and attach securely to
back of controller. Route interface harness through chase. Secure controller to
controller box with screws.
8. Route chase and interface harness from controller to host unit. Secure with clamps.
9. Cut off excess harness and strip wire ends. Crimp onto existing splice and use heat
shrink covering.
10. Apply Superlube (or equivalent) and secure connect remote interface harness
connector to evaporator harness connector.
A. 69.8 mm (2.75 in.)
B. 196.8 mm (7.75 in.)
Eng
58