Project Source 1076627 Manual De Instrucciones página 5

ASSEMBLY INSTRUCTIONS
3. Push the quick connector (C) firmly upward and
attach it to the receiving block (1). Pull down
moderately to ensure the connection has been made.
4. Install the weight clip (G) at the point of the hose
marking "weight here". Insert the weight (F) onto
the clip (G) by sliding it down onto the clip (G).
5. Making the water supply connections：
Thread the nut (1) on the supply line onto the
outlet of the water supply valve (2) and tighten
with a wrench. Do not overtighten.
Note: The hot side inlet tube is indicated by a label.
Avoid twisting wires together or placing the wires
close to each other and damaging.
3
4
G
5
2
5
1
C
F
F
G
1