TFA_No. 35.1165_Anleitung
21.03.2022
Wireless weather station
6.2.5 Weather symbol setting
• For a correct weather forecast the actual weather conditions have to be set (see "weather symbol"). The weather forecast
may be not accurate if the entered weather symbol is incorrect.
7. Alarm clock function
• Press the ALARM button in normal mode.
• OFF, AL and 6:30 (default) or the last adjusted alarm time appear on the display.
• Press and hold the ALARM button for 3 seconds.
• The hour digit starts to flash.
• Press the + or –/CH button to adjust the hours.
• Press the ALARM button again and set minutes in the same way.
• Press the ALARM button again. Press the + or –/CH button to adjust the minutes (5 to 60) for the snooze function or to
switch it off (OFF).
• Press the ALARM button again to return to normal mode.
• Press the ALARM button in normal mode, to activate (ON) or deactivate (OFF) the alarm function. The alarm symbol
appears/disappears on the display.
• When the alarm is activated, the alarm starts to ring when the set alarm time is reached. The alarm symbol flashes on the
display.
• Press briefly any button (except SNOOZE/LIGHT) or press and hold the SNOOZE/LIGHT button and the alarm will stop.
• If the alarm is not stopped manually, the alarm tone automatically turns off after two minutes and will be reactivated at the
same set time in the following day. The alarm symbol remains on the display.
• When the alarm rings, press the SNOOZE/LIGHT button and the snooze function is activated.
• Zz flashes and the alarm will be interrupted for the set time.
• Press briefly any button (except SNOOZE/LIGHT) or press and hold the SNOOZE/LIGHT button and the snooze function will
stop.
36
12:28 Uhr
Seite 19
Wireless weather station
8. Temperature and humidity
8.1 Trend indicators
• The trend arrows indicate whether the values for temperature and humidity are increasing, steady or decreasing.
Temperature/humidity are increasing
Temperature/humidity are stable
Temperature/humidity are decreasing
8.2 Maximum and minimum values
• Press the MEM button in normal mode. MAX and the highest temperature and humidity values (IN and OUT) are displayed
since the last reset.
• Press the MEM button again and MIN and the lowest temperature and humidity values (IN and OUT) are displayed since
the last reset.
• Press the MEM button once more to go back to the current values display.
• The device will automatically quit the MAX/MIN mode if no button is pressed
• Press and hold the MEM button for 3 seconds to clear all recorded readings (display - -).
8.3 Setting of the outdoor temperature alarm
• Press and hold the ALERT button in normal mode.
• The symbol for the upper alarm limit and 70°C (default) or the last adjusted upper outdoor temperature limit flashes on the
display.
• Press the + or –/CH button to set the desired upper limit.
• Confirm with the ALERT button.
37