Charging The Battery Pack (See Fig. A) - Parkside PLG 20 C3 Traducción Del Manual De Instrucciones Original

Charging the battery pack (see fig. A)
CAUTION!
► Always unplug the appliance before you remove the battery
pack from or connect the battery pack to the charger.
NOTE
► Never charge the battery pack at an ambient temperature of
below 10°C or above 40°C. If a lithium-ion battery is to be
stored for an extended period, the charge level should be
checked regularly. The optimum charge level is between 50%
and 80%. The storage climate should be cool and dry and the
ambient temperature should be between 0°C and 50°C.
♦ Connect the battery pack
(see fig. A).
♦ Insert the power plug into the socket. The control LED
up red.
♦ The green control LED
complete and the battery pack
ATTENTION!
♦ If the red control LED
pack has overheated and cannot be charged.
♦ If the red and green control LEDs
that the battery pack
♦ Push the battery pack
♦ Switch off the charger for at least 15 minutes between successive
charging sessions. Also disconnect the power plug from the mains
power socket.
│ GB │ IE
■ 8
to the high-speed battery charger
indicates that the charging process is
is ready.
flashes, this means that the battery
is defective.
into the appliance.
both flash, this means
PLG 20 C3
lights