Control Panel - Klarstein METROBREEZE ROM Manual De Instrucciones

EN
30

CONTROL PANEL

POWER Press this key to switch on the device. The power indicator will
start to light up.
MODE Press this button while the unit is on or the timer is set to
select a mode such as cooling, dehumidification or fan.
UP/DOWN If the timer is off or on, you can use these buttons to set the
time after which the unit will automatically turn on or off. The
corresponding indicator light on the display will turn on. If the
device is in cooling mode, you can use these keys to set the
temperature. Press both keys simultaneously to switch from °C
to °F and back.
SPEED Press this button to set the speed of the fan: high > medium >
low. Press and hold the keys for 5 seconds in fan mode to start
the internal drying function. Press and hold the keys again for
5 seconds to switch the function off again. The corresponding
indicator light then goes out again.
TIMER Press this key to set the timer. The corresponding control lamp
goes on.
88 The numbers in the large display show the set temperature in
cooling and heating mode. In fan and dehumidification mode,
the room temperature is displayed in °C or °F.
SLEEP If the night mode is started, the corresponding control lamp
lights up in the display.
WATER FULL If the water tank is full, the associated control lamp flashes
while a warning tone sounds.