Care And Cleaning; Risk Of Electric Shock; Cleaning Agents - Thermador Masterpiece VCI3B30ZS Guia De Instalacion

Ocultar thumbs Ver también para Masterpiece VCI3B30ZS:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

C A R E A N D C L E A N I N G
WARNING
To avoid risk of fi re and explosion do not use fl ammable liquids or
solvents. Always switch power off at the service panel and lock the panel
to prevent the power from being switched on accidentally.
Do not use steam cleaners to clean the appliance.
Hidden surfaces may have sharp edges. Use caution when
reaching behind or under appliance.
WARNING

RISK OF ELECTRIC SHOCK

Moisture penetration can cause electric shock. Only clean appliance with
a damp cloth. Prior to cleaning, switch power off at the service panel and
lock the panel to prevent the power from being switched on accidentally.

Cleaning agents

To prevent various surfaces from becoming damaged due to incorrect
cleaning agents, follow the specifi cations given in the table. Do not use:
cleaning agents that are harsh or scouring,
cleaning agents with high alcohol content,
hard scouring pads or sponges,
high-pressure cleaners or steam cleaners.
Thoroughly rinse all new sponges before use.
Observe all instructions and warnings accompanying cleaning agents.
Area
Cleaning agents
Stainless steel
Warm soapy water:
Clean with a non-abrasive, non-sponge
dish towel and dry with a clean, soft
towel.
Clean stainless steel surfaces in the grain
direction only.
Apply the Thermador Stainless Steel
Conditioner (part # 00576697) available
for purchase from customer service. Apply
a thin layer of the care product with a soft
cloth.
Painted surfaces
Warm soapy water:
Clean with a non-abrasive, non-sponge
dish towel and dry with a clean,soft
towel.
Do not use stainless steel cleaner.
Aluminum and plastic
Glass cleaner:
Clean with a soft cloth.
Glass
Glass cleaner:
Clean with a soft cloth. Do not use a glass
scraper.
Controls
Warm soapy water:
Clean with a non-abrasive, non-sponge
dish towel and dry with a clean, soft
towel.
Risk of damage to electronics due to
moisture penetration. Never clean controls
with a wet cloth.
Do not use stainless steel cleaner.
Page 15

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido