Balluff BTL PF 400 Serie Instrucciones De Montaje página 5

BTL PF _ 400- _ _ _ _ -C15A _ _ _ _ - _ _ _ _ _ _
Magnetostrictive Linear Position Sensor – Profile Style
The CE Mark verifies
that our products meet the requirements
of the current EU Directive.
About this guide
This guide provides all the information required for the
installation and connection of the BTL magnetostrictive
linear position sensor with analog current and voltage
interface.
It applies to the following models:
BTL PF _ 400- _ _ _ _ -C15A _ _ _ _ -000S32
–
BTL PF _ 400- _ _ _ _ -C15A _ _ _ _ -CA5000
–
Intended use
The BTL magnetostrictive linear position sensor, together
with a machine controller (e.g. PLC), comprises a position
measuring system. It is intended to be installed into a
machine or system and used in the industrial sector.
Proper function according to the information in the
technical data is only guaranteed if the product is used
solely as described in the user's guide and the associated
documents as well as in compliance with the technical
specifications and requirements and only with a suitable
original Balluff accessory.
Otherwise, it is deemed non-intended use. Non-intended
use is not permitted and will result in the loss of warranty
and liability claims against the manufacturer.
Reasonably foreseeable misuse
The product is not intended for the following applications
and areas and may not be used there:
– In safety-oriented applications in which personal safety
depends on the device function
– In explosive atmospheres
– In food applications
Null point
13 67
2)
M16
~80
3)
Mounting clamps with insulating bushes and
ISO 4762 M5x25 cylinder head screws, max.
tightening torque 2 Nm
1) Not included in scope of delivery
2) Unusable area
3) only for BTL PF1400-... included in scope of delivery
www.balluff.com
End point
Measuring length
Magnet
1)
BTL5-A-3800-2
~250 ~250
15
Other applicable documents
A comprehensive user's guide and additional information
about this product can be found at www.balluff.com on
the product page.
Safety notes
Activities such as installation, connection and startup
may only be carried out by qualified personnel.
Qualified personnel are persons whose technical
training, knowledge and experience as well as knowledge
of the relevant regulations allows them to assess the work
assigned to them, recognize possible hazards and take
appropriate safety measures.
The operator is responsible for ensuring that local safety
regulations are observed.
In particular, the operator must take steps to ensure that a
defect in the product will not result in hazards to persons
or equipment.
The product must not be opened, modified or changed. If
defects and unresolvable faults occur in the product, take
it out of service and secure against unauthorized use.
Dimensions and function
To determine the position of a plant component, a magnet
is connected to the component. Together they are moved
along a waveguide located inside the BTL.
70
2)
~80
18
S32
LED
34.8
50
68
Cable
english 1